Includes a set of (4) NOS Rear Fender Rubber Grommets for the rear fender.
 

$14.50 (HVC20101)

Includes:
1. Three internal pump seals, Large and small.
2. Engine side cover seal
3. Pump to side cover mating gasket and body gasket
 

$32.99 (HVC200103)

$18.99 (1L9-82540-00-00)

$2.85 (93210-29196-00)

• ID 14.5mm

• OD 21mm

• Use on either the drain plug or the shift tension bolt

$3.50ea (4F4-14766-00)

Can be used for either a replacement Drain Plug or the Shifter Tension Bolt.

$4.99 (90109-14385)

• Reproduction damper

• OEM pn 168-25346-00

• Set of four

$39.99 (030559-1)

Fork Dust Boots RD, R5 1970-1975 34mm

Click Here

FORK SEALS

Yamaha R5, DS7 Air Cleaner Joint

• No longer available from Yamaha

• HVC reproduction item,

• Guaranteed to fit like an original part

• High quality molded rubber.

• Fits 1970 to 1972 R5 and DS7 models

• Sold as a set of two.

$54.99 (278-14455-00)

Intake Band Clamp

• Fits the Carb side of the air cleaner joint pictured to the right

• 1 clamp required for each boot

• OEM Style

• Includes the clamp and screw

$2.99ea (90460-49058)

Intake Joint Spring Band

• Fits the air box side of the air cleaner joint pictured to the right

• 1 required for each Joint

$4.99ea (278-14456-00)

4mm X 13mm

Left hand side crank shaft   to generator rotor     woodruff key

OEM Yamaha Part

$6.99 (90280-04005)

Reproduction Shift Shaft.

Applications

• Yamaha R5, DS7 1970-1972

• Yamaha RD250, RD350 1973-1975

• Yamaha RD400 1976-1978

Includes

• Shifter shaft

$69.99 (278-18101-01-00)

• Reproduction Cover

• OEM pn
  168-27433-10

• Sold as each.

$13.99 (168-27433-10)

Yamaha 1970-1972 R5, DS7

• Reproduction item

• OEM pn 214-21761-00

• Replace your leaking or clouded over view glass.

$21.99 (214-21761-00)

Twist Off Fuel Caps

• Available in 2 sizes

  • Large3 3/8 inch (85mm)

  • Small 2 1/2 inc (63mm)

• Includes Seal

• Caps are as pictured
  
  
  

$25.99 (HVC200107-1) Large

$25.99( HVC200107-2) Small

• Kit includes 4 replacement rubber pads

• Installs into the bottom of the seat pan.

$18.99 (HVC200110)

Yamaha Counter shaft Nut

Fits RD 250.350,400, R5, DS7 1970-1979

CLICK HERE

The Clutch push rod wears over time creating a leak around the seal. The push rod is no longer available from Yamaha.  Replace your worn or bent push rod with A HVC reproduction push rod.  Made to exact factory specs.

Applications

• Length 215mm RD, R5, DS7 1970-1975

$12.99 (237-16357-01-00)

Fits RD 250.350,400, R5, DS7 1970-1979

$8.99 (90507-25023)

• R5, DS7, RD250, RD350, RD400

• HVCcycle reproduction part

• No longer available from Yamaha

• Set of four, to mount one foot peg bracket

$34.99 (278-27414-01-00)

• Very rarely do you find an RD or R5 with the stock air box cover strap in place. Finally a solution, HVC's simple but effective strap will secure the air box cover in place.

• Replacement for Yamaha Part Number 278-14459-00-00

$14.99 (HVC200114)

• No longer available from Yamaha

• HVCcycle reproduction part

• Sold as a set of two

• Applications

  • 1967-1969 YR1,2,3

  • 1970-1972 R5, DS7

  • 1973-1975 RD250, RD350

  $8.73 (148-25412-00)

Includes Spring, Ball Washer and Retainer Clip

Applications

• R5, DS7

• RD250/350/400 1973-1979

• Other Early Model Yamahas

• HVC Billet Aluminum Kick Starter

$ 9.99 (HVC20046A)

• Replace your old or missing neutral wire isolator

• Located under the L/H engine side cover

• Applications

  • Fits all Yamaha 2 stroke twins 1970-1979,

  • Yamaha RZ 84-85

$3.50 (HVC200116)

• HVC Reproduction Item
• Fits into the left side cover
• Replace your hard dried out guide with our new guide.
• Fits Yamaha R5, DS7,RD350, RD400

$9.00 (HVC200118)

• HVC Signature Item
• Block off the gap when you remove the oil injection pump and hoses
• Fits into the left side cover.
• Fits Yamaha R5, DS7,RD350, RD400

$9.00  (HVC200118-1)