 |
Step
1- Strip the end
of the wire that you are going to install
the terminal on. |
 |
Step
2 - Check that
the length of wire sticking out of the
insulation is the right length and trim as needed. |
 |
Step
3 - squeeze in
terminal a little so that it will fit better in the
crimper tool. Don't over do it.
|
 |
Step
4 - insert the
terminal in the crimper so that the part you
are crimping is flush with the back of the tool.
Also make sure the other end of the terminal isn't going to be
damaged when you crimp. |
 |
Step
5 - Squeeze with
all your might... |
 |
Step
6 - Move the
terminal to the rear slot in the tool with the
back of the terminal flush with the tool. |
 |
Step
7 - Squeeze with all your might...
|
 |
Step
8 - Take the
terminal out of the tool and it should look
like this. |
